Tormek MSK-250 Stainless Steel Main Shaft Hardware and Bearing for T7 & 2000

Tormek MSK-250 Stainless Steel Main Shaft Hardware and Bearing for T7 & 2000

The shaft, washer and EzyLock nut are all made of stainless steel. The EzyLock ensures that the grindstone is held securely with no danger of unwinding. Unique design requires no tools to mount or loosen the grindstone.

With the Tormek EzyLock, which is both a nut and a washer, you need no tools for mounting and dismounting the stone. The special pitch on the left hand thread causes the rotation of the wheel to tighten the nut to the right torque.

When mounting the grindstone, turn by hand the Ezylock nut anticlockwise into position. It will automatically tighten to the right torque during the first sharpening.

If you need to change stone, turn the stone clockwise while fixating the leather honing wheel with the other hand and the EzyLock will easily loosen.

This construction makes it easy to work with different grindstones, from the Tormek Original Grindstone to the specialty stones Blackstone Silicon for High Speed Steel and the 4000 Grit Japanese Waterstone.

Fits Tormek T-8, Tormek T-7, Tormek 2000 and all older models with 250 mm stone diameter.

Includes:

• Stainless steel nut with EzyLock
• Washer
• Nylon bearings.

Holes for the drive pin
New drive wheels
New drive wheels have a deep groove for the drive pin. Use pre-drilled hole.

Older drive wheels
Older drive wheels have a shallower groove (5 mm or 3/16") for the drive pin. You can either buy a new drive wheel (Art. No: R23) or drill a ∅ 4 mm hole. See the instruction for more information.